Siemens dishwasher Manual de Instruções - Página 18

Imprimir página

S witching off automatically after

S w i t c h i n g o f f a u t o m a t i c a l l y a f t e r t h e e n d o f t h e p r o g r a m m e

the end of the programme *

* depending on model

To save energy, the dishwasher is

switched off 1 minute after the programme

ends (factory setting).

Automatic disconnection can be adjusted

from

to :

Appliance does not switch off

automatically

Off after 1 min

Off after 120 min

– Open the door.

– Switch on ON/OFF switch (.

– Hold down programme button # and

press START button ` until : ... is

indicated on the digital display.

– Release both buttons.

The LED for button # flashes and the

digital display h displays the factory

setting :

– Press programme button # until the

factory set value

the digital display h.

To change the setting:

– Press programme button 3.

Each time the button is pressed, the

set value increases by one level; when

the value of :

the display jumps back to :

– Press START button `.

The set value is saved.

– Close the door.

Switching off the appliance

Short time after the end of the programme:

– Open the door.

– Switch off ON/OFF switch (.

– Turn off the tap (not applicable if Aqua-

Stop fitted).

– Remove the utensils when they have

cooled down.

ã=

Warning

At the end of the programme please open

the door fully and not partially when

emptying the dishwasher. Any escaping

water vapour could damage sensitive

worktops.

is indicated on

has been reached,

(off).

Interrupting the programme

– Open the door.

– Switch off ON/OFF switch (.

The LEDs go out. The programme is

saved.

If the door was opened on an

appliance which has a warm water

connection or is heated, first leave the

door ajar for several minutes and then

close. Otherwise, expansion (pressure)

may cause the appliance door to

spring open or water to run out of the

appliance.

– To continue the programme, switch on

the ON/OFF switch ( again.

– Close the door.

T erminating the programme

T e r m i n a t i n g t h e p r o g r a m m e

(Reset)

– Open the door.

– Press START button ` for

approx. 3 sec.

The numerical display h indicates

– Close the door.

The programme sequence lasts

approx. 1 min. On the digital display

h is indicated :

– Open the door.

– Switch off ON/OFF switch (.

– Close the door.

Changing the programme

When the START button ` has been

pressed, the programme cannot be

changed.

The only way a programme can be

changed is by Cancel programme (Reset).