Siemens dishwasher Manual de Instruções - Página 16

Imprimir página

T imer programming *

T i m e r p r o g r a m m i n g

* depending on model

You can delay the start of the programme

by 3, 6 or 9 hours.

– Switch on ON/OFF switch (.

– Keep pressing the Preselected starting

time button 0 until the appropriate

display 3h, 6h or 9h is lit.

– Press START button h, timer

programming is activated.

– To delete the preselected starting time,

keep pressing the Preselected starting

time button 0 until none of the

displays 3h, 6h or 9h is lit.

You can change your programme

selection at any time until the

programme starts.

End of programme

The programme has ended when the End

display ` is lit.

The end of the programme is also

indicated by an acoustic signal. The

buzzer volume can be set in 4 stages.

Accordingly 0, 1, 2 or 3 displays are lit

(see water hardness table). Factory

setting: 2. This function can be changed

as follows:

– Open the door.

– Switch on ON/OFF switch (.

– Hold down button > P and press

START button h until the End display

` and salt refill indicator )* flash.

– Release buttons.

– Keep pressing button > P until the

salt refill indicator )* and rinse aid

refill indicator )" flash.

– Release buttons.

The refill indicators )* and )" flash

and the displays # and + are lit

(= Setting 2). The set buzzer volume

can be heard.

To change the setting,

– Press the button < H until the

required setting has been selected.

– Press START button h.

The displays go out. The selected

setting is saved.

– Close the door.

Note

To save energy, the dishwasher

automatically switches off after 2 minutes

after the end of the programme.

Switching off the appliance

Short time after the end of the programme:

– Open the door.

– Switch off ON/OFF switch (.

– Turn off the tap (not applicable if Aqua-

Stop fitted).

– Remove the utensils when they have

cooled down.

ã=

Warning

At the end of the programme please open

the door fully and not partially when

emptying the dishwasher. Any escaping

water vapour could damage sensitive

worktops.

Interrupting the programme

– Open the door.

– Switch off ON/OFF switch (.

The LEDs go out. The programme is

saved.

If the door was opened on an

appliance which has a warm water

connection or is heated, first leave the

door ajar for several minutes and then

close. Otherwise, expansion (pressure)

may cause the appliance door to

spring open or water to run out of the

appliance.

– To continue the programme, switch on

the ON/OFF switch ( again.

– Close the door.