Siemens SN Series Manual de Instruções - Página 25

Procurar online ou descarregar pdf Manual de Instruções para Máquina de lavar loiça Siemens SN Series. Siemens SN Series 46 páginas. Dishwasher
Também para Siemens SN Series: Instruções de funcionamento (38 páginas), Manual de Instruções (38 páginas), Manual de Instruções (42 páginas), Manual de Instruções (42 páginas), Manual de Instruções (44 páginas), Manual de Instruções (44 páginas), Manual de Instruções (42 páginas), Manual de instruções (48 páginas), Manual de Instruções (40 páginas), Manual de Instruções (42 páginas), Manual de Instruções (44 páginas), Manual de Instruções (40 páginas)

Imprimir página
Siemens SN Series Manual de Instruções
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display h.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
T imer programming *
T i m e r p r o g r a m m i n g
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press button P + until the digital
display h jumps to œ:‹‚.
4. Press P + or – button until the
displayed time corresponds with your
requirements.
5. Press START button `, timer
programming is activated.
the P + or – button until h œ:‹‹
6. To delete timer programming, press
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
7. Close the door.
Operating the appliance

End of programme

value ‹:‹‹ is indicated on the numerical
The programme has ended when the
display h.
The end of the programme is also
indicated by an acoustic signal. This
function can be changed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button ` until
•:‹.... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display h displays the
factory setting •:‹....
5. Press programme button # until
the factory set value ›:‹ƒ is
indicated on the digital display h.
To change the setting,
1. Press programme button 3. Each
time the button is pressed, the set
the value of ›:‹„ has been reached,
value increases by one level; when
the display jumps back to ›:‹‹ (off).
2. Press START button `, the set
value is saved.
3. Close the door.
en
25