Siemens ED8 FW Series Manual de instruções - Página 10
Procurar online ou descarregar pdf Manual de instruções para Hob Siemens ED8 FW Series. Siemens ED8 FW Series 28 páginas.
Também para Siemens ED8 FW Series: Manual de instruções de utilização (16 páginas)
Imprimir página
Operating the appliance
en
Residual heat indicator
The hob has a residual heat indicator for each hotplate.
This indicates that a hotplate is still hot. Do not touch a
hotplate while the residual heat indicator is lit up.
The following indicators are shown depending on the
amount of residual heat:
Display
•
: High temperature
■
Display
: Low temperature
œ
■
If you remove the cookware from the hotplate during
cooking, the residual heat indicator and the selected
heat setting will flash alternately.
When the hotplate is switched off, the residual heat
indicator will light up. Even after the hob has been
switched off, the residual heat indicator will stay lit for as
long as the hotplate is still warm.
10
1Operating the appliance
T his chapter explains how to set a hotplate. The table
O p e r a t i n g t h e a p p l i a n c e
shows heat settings and cooking times for various
meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: Touch the
sounds. The indicator next to the main switch and the
hotplate indicators
light up. The hob is ready to use.
‹
To switch off: Touch the
goes out. All hotplates are switched off. The residual
heat indicator remains lit until the hotplates have cooled
down sufficiently.
Notes
The hob switches off automatically if all hotplates
■
have been switched off for more than 20 seconds.
The selected settings are stored for four seconds
■
after the hob has been switched off. If you switch it
on again during this time, the hob will operate using
the previously stored settings.
Setting the hotplate
The desired power level is set in the programming
panel.
Power level 1 = minimum power.
Power level 9 = maximum power.
Each power level has an intermediate setting. This is
marked with a dot.
Notes
To protect the fragile parts of your appliance from
■
overheating and electrical overloading, the hob may
temporarily reduce the power.
In order to prevent the appliance from producing
■
excess noise, the hob may temporarily reduce the
power.
Selecting a hotplate and heat setting
The hob must be switched on.
Touch the
symbol for the required hotplate. The
³
1.
indicator lights up.
¬
Then select the required heat setting from the
2.
settings range.
The heat setting is set.
symbol. An audible signal
#
symbol until the indicator
#