Siemens EH70S501E Manual de instruções - Página 26
Procurar online ou descarregar pdf Manual de instruções para Hob Siemens EH70S501E. Siemens EH70S501E 31 páginas.
Imprimir página
Cleaning the hob
surround
Procedure in the event of a malfunction
The circuit breaker in your
household electrical circuit
trips when you switch on
the hob
E is flashing in all the
hotplate displays and a
signal is sounding
The hob has switched itself
off
The display flashes (there
is no power) when you
place a saucepan on an
induction hotplate
26
Only use warm soapy water.
Do not use anything which is sharp or abrasive. The
glass scraper is unsuitable. The hob surround could
be damaged.
Neither lemon juice nor vinegar should be used for
cleaning the hob surround.
This could result in matt patches.
Malfunctions often have simple explanations and may
be easily rectified. Please read the following
instructions before calling the after sales service.
Make sure that the power draw of all the appliances
switched on does not exceed your maximum
household electricity supply. Check whether the
circuit breaker triggers when you switch on another
hotplate.
The control panel is very dirty, food has been spilt or
an object has been placed on the work surface. Clean
the control panel thoroughly or remove the object
from the work surface. Press the control panel
concerned. The flashing stops.
The main switch was touched inadvertently. Switch
the hob back on. Adjust the settings again.
Check whether the saucepan is electromagnetic
(attracts a magnet). Check whether the diameter of
the saucepan is large enough.
Allow the saucepan to cool down in the event that it
has become too hot when used.
If the display still does not light up when you switch
the hotplate off and on again, disconnect the
appliance from the mains. Wait 20 seconds and then
reconnect it.