Digital Matter G62 Manual de instalação - Página 12
Procurar online ou descarregar pdf Manual de instalação para GPS Digital Matter G62. Digital Matter G62 15 páginas.
Também para Digital Matter G62: Manual de iniciação (3 páginas)
Imprimir página
Digital Matter
2. Remote Immobilisation - Device can be sent a command to immobilise the vehicle.
6.4.1. Wiring for Immobilisation on no Driver ID
See our Knowledge Base article on this:
1. Connect the relay coil positive (PIN 86), to the vehicle positive
2. Connect the relay coil negative (PIN 85), to the switched ground output (GREEN on G62)
3. Use the common (PIN 30) and Normally Open (PIN 87) contacts to control the starter
motor.
In this configuration the relay is not energised until the driver ID is scanned, at which point it will
be energised allowing the vehicle to be started.
See Appendix A – Wiring Diagram – Immobilisation on no Driver ID for a wiring diagram
for this configuration.
6.4.2. Wiring for Remote Immobilisation
1. Connect the relay coil positive (PIN 86), to the vehicle positive
2. Connect the relay coil negative (PIN 85), to the switched ground output (GREEN on G62)
3. Use the common (PIN 30) and Normally Closed (PIN 87a) contacts to control the starter
motor.
In this configuration the relay is energised when the command is sent from the server to
immobilise, and the starter motor is cut.
G62 Installation Guide
G62 Immobilisation Setup for Access Control
All information provided in this document is subject to legal disclaimers
Revision 1.0 - 20 September 2018
G62 Install Guide
© Digital Matter 2018
Page 12 of 15