Epson EB-L25000U Manual de instalação - Página 7
Procurar online ou descarregar pdf Manual de instalação para Projetor Epson EB-L25000U. Epson EB-L25000U 13 páginas.
Também para Epson EB-L25000U: Atualização do firmware (16 páginas)
Imprimir página
Transport and Installation Handbook
Notes on Installation
Notes on the Installation Environment
Do not use or install the projector where it may be subject to water or rain,
or high humidity, such as outdoors, in a bathroom, or shower room, and so
on.
Otherwise, it could cause a fire or electric shock.
Do not place flammable objects in front of the lens.
If you set the schedule to turn on the projector automatically, any flammable objects placed
in front of the lens could cause a fire.
Check the following points before installing.
•
Make sure the location is not subject to vibrations or shocks.
•
Make sure the location does not shake and is not tilted at an angle.
•
Makes sure there are no high-voltage lines or magnetic devices in the surrounding environ-
ment.
Do not use or store the projector in a location that is subject to extreme
temperatures.
Also, avoid sudden temperature changes.
Make sure you use or store the projector in a place that is within the following operating or
storage temperature ranges.
•
Operating temperature range
0 to +50°C (Altitude of 0 to 1,500 m, humidity of 20% to 80%, and no condensation)
0 to +45°C (Altitude of 1,501 to 3,048 m, humidity of 20% to 80%, and no condensation)
•
Storing temperature range
-10 to +60°C (No condensation)
Do not install the projector in direct sunlight.
If the projector is in direct sunlight, the internal temperature increases, which could cause
parts such as the surface of the projection lens or the built-in camera to deteriorate.
When installing the projector in an environment in which a high-powered
laser beam is being used, make sure it is installed so that the laser beam
does not hit the surface of the projector's projection lens or the built-in
camera.
If the laser beams through the surface of the projection lens or the built-in camera, block the
laser beam with non-permeable or incombustible aluminum foil or metal plates such as iron
to protect the projection lens and the built-in camera.
Warning
Caution
6