Ricoh 77753 Manual de serviço - Página 5

Procurar online ou descarregar pdf Manual de serviço para Câmara digital Ricoh 77753. Ricoh 77753 13 páginas.

Ricoh 77753 Manual de serviço
Outline of Assemble and Disassemble

1. Caution

1. Be sure to use the anti-static mat and wrist strap to prevent static failure of circuits.
2. This product is used lead free solder.
Surface of solder will be white-tinged color. Solder quickly, because melting temperature is high and so if
heat too much, it is possible to damage to PC board. Soldering iron requirement: The temperature can be
adjusted up to 400℃ and exclusive use for lead free solder. Also it is desirable to use antistatic soldering
iron. The temperature for tip of soldering iron must set between 340℃~360℃ for lead free solder.
3. Do not stress to the connector terminals and flexible boards because they are very delicate parts. Pay
careful attention to the connector terminals and flexible boards and, we recommend marking to the flexible
board before disconnecting them. This will be helpful to reconnect the flexible board to the connector
terminal properly.
4.Paste parts of that tape and etc. Follow the instructions in the service manual paste, so there is no float or
drift. Specially, there is a risk of a short copper foil tape and gaskets to connector.
(If adhesive tape of glue weaken, it must replace to new one.)

2. Flow chart for assembling body and Front housing

*The same as K-30(77650)
III. Assembling body
1. E000 (Shutter block)
2. 0-A101 (Front housing)
3. A6 (Upper L plate)
4. T700 (Upper flex P.C. board)
5. T980 (RAW SW board)/T940(AF select SW board)
6. A4(R Plate)
7. T750 (Flash flex board)
8. T901 (Lower flex P.C. board)
9. 0-A51 (Tripod plate)
10. [Conf] Height of SR Base Plate Support Pillar
11. 0-C000 (SR Block)
12. [Adj.] Height of 0-C000
13. T100 (Main P.C. board)
14. [Adj.] J100 position
15. 0-M311 (Eyepiece frame)
16. A150 (Front cover) /A201(Back cover)
...If M100 adjust, attached temporary cover(A150)
17. A301 (Top cover)
18. A401 (Bottom cover)
...If M100 adjust, attached temporary cover(A401)
19. [Adj.] AF-CCD position
II. Front housing block
1.A101 (Front main body assy)
2.A104 (Mount ring)
3.[Adj.] AF joint stroke
4.0-B52 (Mirror part)
5.[Adj.] First/second mirror angle
6.S250 /G100(Mirror motor part)
7.[Conf] Mirror function
8.Penta mirror part (M27)
9.[Adj.] Finder focus/Parallax
10. Finder part (O100)
11. [Adj.] O100 position
12. M100 (AF Block)
13. J100 (Photo sensor block)
14. M51, O170 (SI Block)
15. [Adj.]SI-LED position
[Ⅳ
77750 - 4/12 -
Adjustment/Confirmation]