Ricoh PB3040 Manual de instalação - Página 3

Procurar online ou descarregar pdf Manual de instalação para Acessórios para impressoras Ricoh PB3040. Ricoh PB3040 4 páginas. Paper feed unit

Imprimir página

Pull out tray 2 of the printer slow-

ly until it stops, lift the front of

the tray slightly, and then pull out

the tray completely.

Place the tray on a flat surface.

Attach a screw in the hole on the

left side of the tray opening to se-

cure the printer to the paper feed

unit.

Tighten the screw firmly using a

coin.

Lift the front of the tray, and slide

it carefully into the printer until it

stops.

On the rear of the unit, attach two

brackets using the remaining

screws.

Tighten the screws firmly using a coin.

BEK103S

Plug in the power cord, and then

turn on the printer.

Print the configuration page to

confirm that the unit was attached

correctly.

Note

❒ To confirm whether the optional

paper feed unit was correctly at-

tached, print the configuration

page, and check "Attached Equip-

ment" on the configuration page. If

the unit was attached correctly, the

following will be displayed:

• 1000-sheet paper feed unit:

Lower Paper Trays

• 2000-sheet paper feed unit: Tray 3

BEJ115S

❒ If the optional paper feed unit was

not installed properly, repeat the

procedure from step 2. If it cannot

be installed correctly even after reat-

tempting installation, contact your

sales or service representative.

Reference

For information about printing the

configuration page, see "Test Print-

ing", Quick Installation Guide

If the print area is not centered cor-

rectly, see "Adjusting Printing Po-

sition", Hardware Guide

BEK105S

BEK106S