Cisco 1700 series Manual de síntese - Página 11

Procurar online ou descarregar pdf Manual de síntese para Router de rede Cisco 1700 series. Cisco 1700 series 13 páginas. Secure firewall management center
Também para Cisco 1700 series: Manual de informações sobre conformidade regulamentar e segurança (45 páginas), Manual (15 páginas), Manual de configuração (25 páginas), Nota de aplicação (41 páginas), Resolução de problemas de hardware (12 páginas), Configuração (34 páginas), Manual (5 páginas), Manual de início rápido (6 páginas), Manual de instalação do hardware (46 páginas)

Additional Required Equipment

Depending on your local network and which Cisco WAN interface cards you install in your

router, you will require other items, listed in Table 1-5, to complete your router installation.

Table 1-5

Equipment

Ethernet hub

Ethernet switch

Phillips screwdriver

Cisco WAN interface card

Straight-through

RJ-45-to-RJ-45 cable

Serial cable

NT1

Asynchronous modem

Additional Required Equipment

When You Use It

A hub connects pieces of network equipment (including the

Cisco 1700 router) to create a network. You can use a 10-, 100-,

or 10/100-Mbps hub with the Cisco 1700 router.

A switch connects pieces of network equipment (including the

Cisco 1700 router) to create a network. You can use a 10-, 100-,

or 10/100-Mbps switch with the Cisco 1700 router.

Although the WAN interface cards use thumbscrews, you might

need a Phillips screwdriver to loosen the WAN interface card

slot cover.

In order to make a WAN connection, the Cisco 1700 router must

have a supported WAN interface card installed. The router

supports up to two cards. You can order the cards when ordering

the router, and they will be installed for you. You can order the

cards separately, after receiving the router, and install them

yourself.

This cable connects the router to the Ethernet LAN and the

WAN interface cards to various WAN services, including ISDN,

T1/FT1, and 56-kbps services. You will need one cable for each

connection that requires this cable type.

This cable connects a serial card to serial services. You must

order this cable from Cisco. For detailed information about

serial cable types, refer to the Cisco WAN Interface Cards

Hardware Installation Guide that comes with every card.

Some ISDN service providers require a Network Termination 1

device to connect an ISDN S/T port to the ISDN line.

Connect a modem to the AUX port on the router when you want

to conﬁgure the router from a remote location.

Additional Required Equipment

Cisco 1700 Router Overview 1-11