Cisco 1710 Manual de início rápido - Página 7

Procurar online ou descarregar pdf Manual de início rápido para Router de rede Cisco 1710. Cisco 1710 13 páginas. Security access routers
Também para Cisco 1710: Ficha de dados (11 páginas)

Imprimir página
8

Verify Your Installation

After the router is powered on, the following LEDs confirm that you have correctly installed your router.
LED
PWR
OK
LNK (One for each Ethernet
port)
FDX (One for each Ethernet
port)
100 (10/100 ETHERNET port
only)
10BT ACT and 10/100 ACT
9

For More Information

For more information about installing or configuring your Cisco 1710 Security router, see the following documents available
on Cisco.com:
• Cisco 1710 Security Router Hardware Installation Guide
• Cisco 1710 Security Router Software Configuration Guide
• Cisco Security Device Manager Troubleshooting Guide
• The Cisco Warranty card, included in the accessory kit, which lists telephone numbers, e-mail addresses, and World Wide
Web URLs for getting information directly from Cisco Systems
For more information about SDM, visit http://www.cisco.com/go/sdm
10

Obtaining Documentation

Cisco documentation and additional literature are available on Cisco.com. Cisco also provides several ways to obtain technical
assistance and other technical resources. These sections explain how to obtain technical information from Cisco Systems.
Cisco.com
You can access the most current Cisco documentation at this URL:
http://www.cisco.com/univercd/home/home.htm
You can access the Cisco website at this URL:
http://www.cisco.com
Panel
What to Look For
Front
On when power is being supplied to the router.
Front
On when the router software is loaded and
functional.
Blinking when the router is running a power-on
self-test (POST). Continual blinking can indicate a
problem with the router, although the LED will
also blink if the router is in ROMMON mode.
Refer to the "Troubleshooting" chapter in the
hardware installation guide for more information.
Back
On when the router is correctly connected to the
Ethernet network through the 10BT and 10/100
ETHERNET ports.
Back
On when the associated Ethernet port is operating
in full-duplex mode. The 10BT port does not
perform autosensing for full-/half-duplex mode;
the default setting is for half-duplex operation.
Back
On when the 10/100 ETHERNET port is
operating at 100 Mbps.
Front
Blinking when there is network traffic on the
Ethernet connections.
7