Cisco 1712 - Security Access Router Manual de instalação do hardware - Página 15
Procurar online ou descarregar pdf Manual de instalação do hardware para Router de rede Cisco 1712 - Security Access Router. Cisco 1712 - Security Access Router 21 páginas. Security access routers
Também para Cisco 1712 - Security Access Router: Manual de início rápido (13 páginas), Ficha de dados (8 páginas)
Imprimir página
Chapter 2
Installation
Step 2
Caution
Stacking the Router
Note
OL-4050-02
Hang the router on the screws with either the left side or right side mounting
brackets so that
The LEDs are visible to the user—Because the LEDs indicate the router
•
operating status, they need to be easily visible.
The power supply does not hang from its cable—If the power supply is not
•
supported, it might disconnect from the cable that connects it to the router.
If you install the screws in drywall, use hollow-wall anchors (1/8 inch
by 5/16 inch) to secure the screws. If the screws are not properly anchored, the
strain of the cables connected to the router rear-panel connectors could pull the
router from the wall.
You can stack one Cisco 1711 Security Access router and/or one Cisco 1712
Security Access router in a four-device stack, along with other Cisco products
designed to be stacked with the router. You can stack each device directly on top
of another device.
The Cisco 1711 and Cisco 1712 Security Access routers are not shipped with the
stacking equipment described in this section; however, the equipment is included
with all other Cisco products that are designed to be stacked.
Each Cisco product designed to be stacked with the router comes with a stacking
clip and a fastener for keeping the multiple devices together in a stack. Before you
stack the devices, assemble the clip and fastener as shown in
page
2-16.
Cisco 1711 and Cisco 1712 Security Access Routers Hardware Installation Guide
Optional Installation Steps
Figure 2-8 on
2-15