Cisco 1720 Manual de início rápido - Página 5
Procurar online ou descarregar pdf Manual de início rápido para Router de rede Cisco 1720. Cisco 1720 13 páginas. Cabling and installation
Também para Cisco 1720: Manual de início rápido (13 páginas), Ficha de dados (12 páginas)
Imprimir página
Install the WAN Interface Card(s)
Look for a WAN interface card in one or both of the two slots on the rear of the router. If a card is already installed, connect it
to the WAN line according to the <Emphasis>Cisco WAN Interface Cards Hardware Installation Guide that came with the card.
To install a card in either slot, follow these instructions:
Set the power switch to the STANDBY (
Step 1
Remove the screws that hold the slot cover in place, and then remove the slot cover.
Step 2
Figure 2
Locating the WAN Interface Card
C is c o
1 7 2 0
W IC
CO NS
0 O K
O LE
FD X
10 0
LN K
10 /1 00
ET HE
RN ET
AU X
WAN interface card slot cover
Step 3
Hold the card by the edges and line it up with the guide on the card slot.
Step 4
Push the card into the slot until it is seated in the connector and the front panel is flush with the router rear panel.
Figure 3
Installing the WAN Interface Card
C is c o
1 7 2 0
CO NS
W IC
0 O K
O LE
FD X
10 0
LN K
10 /1 00
ET HE
RN ET
AU X
SE E
MA NU
AL BE
FO RE
INS TA
LLA TIO
DS U
N
56 K
WAN interface
Guides
card slot cover
Tighten the screws that are in the card.
Step 5
Connect the card port to the WAN line according to the <Emphasis>Cisco WAN Interface Cards Hardware Installation
Step 6
Guide.
W IC
1O K
W IC
1O K
) position and confirm the router is not connected to the power supply.
5