ActronAir RC-03 Manual de operação - Página 11

Procurar online ou descarregar pdf Manual de operação para Controlo remoto ActronAir RC-03. ActronAir RC-03 16 páginas.

Operation Manual

06. How To Use Advanced Function

Press

button when the unit is turned on.

Vane

Press

button to activate the louver setting feature. Each time you press the

Vane

display the selected louver in an order as("-0" indicates that four louvers are all selected):

Press Swing button to start/stop the auto swing feature of the selected louvers.

NOTE

The system will exit the louver setting mode If there is no operations during a 10 seconds period.

Press

button

The horizontal louver auto swing feature is energized.

Press again to stop the swing.

1. Press the LED button to activate or de-activate the display on the indoor unit.

2. Press and hold the LED button for more than 5 seconds until it beeps, release. Then press and hold again for 5

seconds then release after beeps.

3. After few seconds the room temperature shows.

4. To revert to previous display, repeat steps 2 and 3. To revert the change press LED button until set point shows

on the indoor unit.

1. Press and hold the

indicate it is activated. The compressor will run at a reduced capacity to minimize the operational noise.

NOTE

Due to low compressor frequency operation, this may result in insufficient cooling and heating capacity.

2. Holding

3. Pressing the

4 Louvers

-1

button for more than 2 seconds to activate Quiet Function. Quiet icon will display to

button again for 2 seconds turns off quiet function.

button will also cancel Quiet Mode.

Operation Manual - RC-03 Controller

Document: 9590-4017 Ver. 1 220318

-2

-3

-4

Remote Controller

button, the display panel will

Vane

-5