Cisco 1760V Manual de início rápido - Página 4
Procurar online ou descarregar pdf Manual de início rápido para Router de rede Cisco 1760V. Cisco 1760V 13 páginas. Cabling and installation
Também para Cisco 1760V: Resolução de problemas de hardware (12 páginas)
Imprimir página
4
Install the Router
Follow these steps to install the router.
Connect the Router to the Local Network
You need to provide a straight-through Ethernet cable for connecting the router to the local Ethernet network. For more
information on these cables, refer to the "Cabling Specifications" chapter in the hardware installation guide that came with the
router.
Step 1
Connect one end of the Ethernet cable to the yellow 10/100 ETHERNET port.
Figure 1
Installing the Router
C is c o
1 7 2 0
C O N
W IC
S O LE
0 O K
F D X
1 0 0
L N K
10 /1 00
E TH
E R N
E T
A U X
10/100
Ethernet
port
A U I
8
Straight-through
Ethernet cable
Connect the other end to a 10-, 100-, or 10/100-Mbps port on the hub or switch. The router senses the port speed and
Step 2
duplex mode and then operates at the same speed and duplex.
Caution
Always connect the Ethernet cable to the yellow ports on the router. Do not connect the cable to an ISDN S/T or U
port (on a WAN interface card) or to an NT1 that is connected to a WAN interface card. Accidently connecting the
cable to the wrong port can damage your router.
4
SE E
MA NU
AL BE
FO RE
INS TA
LL AT
DS U
ION
56 K
W IC
1O K
7
6
5
4
3
2
1
Ethernet hub or switch