Cisco 2504 Manual de iniciação - Página 10

Procurar online ou descarregar pdf Manual de iniciação para Router de rede Cisco 2504. Cisco 2504 47 páginas. Wireless controller
Também para Cisco 2504: Manual do utilizador (11 páginas)

Imprimir página

Unpacking and Preparing the Controller for Operation

config port linktrap {port | all} {enable | disable}-Enables or disables the up and down link traps

•

for a specific controller port or for all ports.

configport adminmode {port | all} {enable |disable}-Enables or disables the administrative mode

•

for a specific controller port or for all ports.

The management interface is the default interface for in-band management of the controller and

connectivity to enterprise services such as AAA servers. It is also used for communications between the

controller and access points. The management interface has the only consistently "pingable" in-band

interface IP address on the controller. You can access the GUI of the controller by entering the

management interface IP address of the controller in the address field of either Internet Explorer or

Mozilla Firefox browser.

Following are the steps to configure the management interface:

Enter the show interface detailed management command to view the current management interface

Step 1

settings.

The management interface uses the controller's factory-set distribution system MAC address.

Note

Enter the config wlan disable wlan-number command to disable each WLAN that uses the management

Step 2

interface for distribution system communication.

Step 3

Enter these commands to define the management interface:

–

Note

–

Note

–

Enter the save config command.

Step 4

Enter the show interface detailed management command to verify that your changes have been saved.

Step 5

If you made any changes to the management interface, enter the reset system command to rebo ot the

Step 6

controller in order for the changes to take effect.

Cisco 2500 Series Wireless Controller Getting Started Guide

config interface address management ip-addr ip-netmask gateway

config interface quarantine vlan management vlan_id

Use the config interface quarantine vlan management vlan_id command to configure a

quarantine VLAN on the management interface.

config interface vlan management {vlan-id | 0}

Enter 0 for an untagged VLAN or a nonzero value for a tagged VLAN. We recommend using

tagged VLANs for the management interface.

config interface port management physical-ds-port-number

config interface dhcp management ip-address-of-primary-dhcp-server

[ip-address-of-secondary-dhcp-server]

config interface acl management access-control-list-name