Cisco 2524 - Router - EN Manual de configuração - Página 18

Procurar online ou descarregar pdf Manual de configuração para Router de rede Cisco 2524 - Router - EN. Cisco 2524 - Router - EN 23 páginas. Troubleshooting guide
Também para Cisco 2524 - Router - EN: Manual de configuração (23 páginas), Visão geral (10 páginas), Preparação para a instalação (19 páginas), Manual de resolução de problemas (4 páginas)

Configuring the Router

Take the following steps to configure the 4-wire 56/64-kbps DSU/CSU WAN module for

DDS, substituting the correct addresses and host names as appropriate for your network:

Step 1

Step 2

Step 3

Step 4

Step 5

Configuring the Fractional T1/T1 DSU/CSU WAN Module

This section describes how to configure the fractional T1/T1 DSU/CSU WAN module. This

module is configured for Extended Superframe Format (ESF) signal format, bipolar eight

zero substitution (B8ZS), and full bandwidth as the factory default. Depending on your

networking environment, you might need to change these settings.

For Cisco IOS Release 11.0 and earlier releases, refer to the Router Products Command

Reference for more information about the commands in this section. For Cisco IOS

Release 11.1 and later releases, refer to the Configuration Fundamentals Command

Reference.

4-18 Cisco 2524 and Cisco 2525 Router User Guide

Enter enable mode:

Router> enable

password: enablepassword

Enter configuration mode:

Router# config term

Router(config)#

Assign an IP address to the serial port on the module:

Router(config)# interface serial port_number

Router(config-if)# ip address ipaddress subnetmask

Router(config-if)# no keepalive

Set the network type to DDS:

Router(config-if)# service-module 56k network-type dds

Return to user EXEC mode:

Router(config-if)# exit

Router(config)# exit

Router# exit

Router>