Cisco 2524 - Router - EN Manual de configuração - Página 2

Procurar online ou descarregar pdf Manual de configuração para Router de rede Cisco 2524 - Router - EN. Cisco 2524 - Router - EN 23 páginas. Troubleshooting guide
Também para Cisco 2524 - Router - EN: Manual de configuração (23 páginas), Visão geral (10 páginas), Preparação para a instalação (19 páginas), Manual de resolução de problemas (4 páginas)

Configuring the Router

If after five attempts a valid Cisco IOS image is not found in Flash memory, the router

reverts to boot ROM mode (which is used to install or upgrade a Cisco IOS image).

If a valid Cisco IOS image is found, then the router searches for a valid configuration

file.

If a valid configuration file is not found in NVRAM, the router runs the System

Configuration Dialog so you can configure it manually. For normal router operation,

there must be a valid Cisco IOS image in Flash memory and a configuration file in

NVRAM.

The first time you boot your router, you will need to configure the router interfaces and then

save the configuration to a file in NVRAM. Proceed to the next section, "Configuring the

Router," for configuration instructions.

Configuring the Router

You can configure the router using one of the following procedures:

•

Configuration mode—Recommended if you are familiar with Cisco IOS commands.

•

AutoInstall—Recommended for automatic installation if another router running

Cisco IOS software is installed on the network. This configuration method must be set

up by someone with experience using Cisco IOS software.

•

System Configuration Dialog—Recommended if you are not familiar with Cisco IOS

commands.

Use the procedure that best fits the needs of your network configuration and level of

Cisco IOS experience.

Timesaver

consult your network plan to determine correct addresses before you begin to configure the

router.

4-2 Cisco 2524 and Cisco 2525 Router User Guide

Acquire the correct network addresses from your system administrator or