Cisco 2525 Manual de configuração - Página 15

Procurar online ou descarregar pdf Manual de configuração para Router de rede Cisco 2525. Cisco 2525 23 páginas. Troubleshooting guide
Também para Cisco 2525: Manual de configuração (23 páginas), Visão geral (10 páginas), Preparação para a instalação (19 páginas), Manual de resolução de problemas (4 páginas)

Enter the BRI interface, encapsulation method (PPP), authentication type, target

Step 4

router's IP address and ISDN number to dial, and the dialer group number:

Router (config)# interface bri port_number

Router (config-if)# encapsulation ppp

Router (config-if)# ppp authentication chap

Router (config-if)# dialer map ip targetrouter_ipaddress

targetrouter_phonenumber

Router (config-if)# dialer-group groupnumber

Do not use periods or hyphens when you enter dialing numbers.

Note

Step 5

Some ISDN switch types, such as Basic NI1 or DMS-100 switch service, require

you to conﬁgure a service proﬁle identiﬁer (SPID). Enter the SPID information as

follows, substituting the appropriate entries for your installation:

Router (config-if)# isdn spid1 SPID_no phone_number

Router (config-if)# isdn spid2 SPID_no phone_number

Step 6

To set up a second B channel for bandwidth on demand, enter the load-threshold

command to set the ISDN load threshold. The load threshold determines the

percentage of network loading at which the second ISDN B channel is triggered.

The value ranges from 1 to 255 (100 percent).

Router (config-if)# dialer load-threshold 128

In this example, the value of 128 means that when the ﬁrst B channel reaches

50 percent of its bandwidth capacity (128 equals 50 percent of 255), the second B

channel will be activated to assist with the bandwidth load.

Enter the access-list command to conﬁgure the ISDN line to come up whenever

Step 7

IP packets are to be sent:

Router (config-if)# access-list access-list-number permit ip

sourcerouter-ipnetwork sourcerouter-subnetmask

targetrouter-ipnetwork targetrouter-subnetmask

Router (config)# dialer-list groupnumber list access-list-number

Configuring the Cisco 2524 and Cisco 2525 Routers 4-15

Configuring the Router