Cisco 2600XM Series Manual de início rápido - Página 21
Procurar online ou descarregar pdf Manual de início rápido para Router de rede Cisco 2600XM Series. Cisco 2600XM Series 29 páginas. Including license and warranty
Também para Cisco 2600XM Series: Manual de início rápido (29 páginas), Ficha de dados (6 páginas), Ficha de dados (11 páginas)
Imprimir página
Step 3
Enter a host name for the router (this example uses 2610):
Configuring global parameters:
Enter host name [Router]: 2610
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the
Step 4
configuration:
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: xxxxxx
Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure)
Step 5
and can be seen when viewing the configuration:
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: xxxxxx
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the
Step 6
console port:
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: xxxxxx
Step 7
Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [yes]:
Community string [public]:
A summary of the available interfaces appears:
Step 8
The interface numbering that appears is dependent on the type of Cisco modular router platform and on the
Note
installed interface modules and cards.
Current interface summary
Controller Timeslots D-Channel Configurable modes Status
T1 0/0
24
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
FastEthernet0/0
FastEthernet0/1
Select one of the available interfaces for connecting the router to the management network:
Step 9
Enter interface name used to connect to the
management network from the above interface summary: fastethernet0/0
Step 10 Respond to the following prompts as appropriate for your network:
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: no
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.1.0.0, 16 subnet bits; mask is /16
23
pri/channelized
IP-Address
unassigned
unassigned
Administratively up
OK? Method Status
NO
unset
up
NO
unset
up
Prol
up
dow
21