Useful Functions
The following five colour modes can be selected by pressing [Color
Color Mode
Mode] on the remote control.
•Dynamic
Playback of images and sound can be paused and resumed each
A/V Mute
time [A/V Mute] is pressed on the remote control.
Automatically adjusts the incoming signals when connected to a
Auto Setup
computer to obtain optimum images.
Troubleshooting
•
No images appear:
When using a laptop or a PC with an in-built monitor, select external video output on the computer.
Setup examples
Press and hold the [Fn] key, followed by the appropriate function number key.
NEC
[Fn]+[F3]
Panasonic
Toshiba
[Fn]+[F5]
IBM
[Fn]+[F7]
s User's Guide "Laptop connection"
•
Checking the indicators
These indicators alert you to problems with projector operation.
s Refer to "When You Suspect a Problem" in the User's Guide for further details.
Power indicator
Condition
Standby state
The power cable should only be
Orange
disconnected in this condition.
Projection starts when you press
the [Power] button.
Cool-down in progress
Orange
The projector changes to
standby (indicator lights orange)
after about 20 seconds.
Green
Projection in progress
Warm-up in progress
Green
After warm-up finishes,
projection starts when an image
signal is input.
Printed in China
03.xx-xx(C01)
404333500 (E)
•Presentation
"No signal"
lit
flashing
Cause/Remedy
• Theatre
•Living Room
SONY
Fujitsu
Macintosh
Warning indicator
Condition
High internal temperature (overheating)
The lamp will turn off automatically and
Red
projection will stop. Wait for about 5 minutes,
unplug the power cable and then plug it back
in again. Then press the [Power] button to
turn the projector back on.
Lamp problem
Red
Remove the lamp and check if it is broken. If
the lamp is not broken, re-install it. If the lamp
(0.5 second
is broken replace by a new lamp, or contact
interval)
your local dealer for further advise.
Red
Internal problem
Stop using the projector and send it for
(1 second
service.
interval)
High-speed cooling in progress
If the temperature rises too high again,
Orange
projection will stop automatically.
Check that the air filter and air exhaust vent
are clear, and that the internal room
temperature is not too high.
*1 Contact your dealer for a spare lamp.
*2 For repairs, contact your dealer or the nearest address
provided at "International Warranty Conditions" in
Safety Instructions/World-Wide Warranty Terms.
s User's Guide
"Selecting a colour
•sRGB
mode"
s User's Guide
"A/V Mute"
s User's Guide
"Adjusting computer
generated Images"
s
User's Guide
"Troubleshooting"
[Fn]+[F7]
[Fn]+[F10]
After start up enable "Mirroring" in
the Monitors Control Panel.
Cause/Remedy
*2
lit
flashing
*1