ACTUATECH GD08 Manual de instruções - Página 11
Procurar online ou descarregar pdf Manual de instruções para Controlador ACTUATECH GD08. ACTUATECH GD08 14 páginas. Scotch–yoke part turn pneumatic actuator
Imprimir página
INSTRUCTION MANUAL
SCOTCH–YOKE PART TURN PNEUMATIC ACTUATOR
GD08
C) The pistons O-ring (part N° 12) and supports (part N° 7) should be checked before replacement. Do not use sharp tools to remove
O-ring or the supports from the piston as this may cause furrows or marks.
7
12
D) When the components are disassembled, they should be properly cleaned, and wear checked prior to being greased and reas-
sembled. In case the sealing parts are too much worn out use new parts from the spare parts kit.
Assembly.
A) O-ring (part N° 12) shall be greased and mounted onto the piston seat using a proper conical tool that allows an easy and perfect
slip-in of the items without any damages.
B) Push into its piston seats the supports (part N° 7).
C) Grease the pistons (part N° 2) on the replaced parts (parts N° 7+12).
D) Grease the internal cylinder surface (part N° 1).
E) Position the scotch-yoke shaft (part N° 4) in order to have the groves in position for the pistons insertion (see Fig. B) and the right
shaft required direction of rotation.
F) Insert the pistons (part N°2) in the scotch-yoke grooves (part N° 4) and press simultaneously the two pistons inside of the cylinder
(part N° 1). The ACTUATECH scotch-yoke system will avoid pistons misalignment. Holding the actuator on a vice rotate the shaft to
verify the shaft rotation direction and the easy movement.
G) Replace the cap seal (part N° 8) on its caps seat (part N° 3) and grease it. Fit the end caps to the body screwing the screws in
cross (part N° 16).
N.B. For the screw torque wrench setting see pg. 8.
Fig. A
Fig. B
1
7
12
ACTUATECH S.p.A
Via S. Lorenzo, 70, 25069 Villa Carcina (BS) Italy •
Ph.
+39 030 8908142 •
Fax
+39 030 8908143 • [email protected] •
www.actuatech.com
11
EN -
Rif. MAN80938 - 02/22