CAB EOS5 Manual do operador - Página 6
Procurar online ou descarregar pdf Manual do operador para Fabricante de etiquetas CAB EOS5. CAB EOS5 15 páginas.
Também para CAB EOS5: Manual de serviço (20 páginas)
Imprimir página
6
1
Introduction
1.3 Safety Instructions
•
Disconnect the printer from the electrical outlet before mounting or
removing the cutter.
•
The cutter may only be operated when it is mounted on the printer.
•
Risk of injury, particularly during maintenance, the cutter blades are sharp.
•
Work going beyond this may only be performed by trained personnel or
service technicians.
•
Unauthorized interference with electronic modules or their software can
cause malfunctions. Other unauthorized work on or modifications to the
device can also endanger operational safety.
Always have service work done in a qualified workshop, where the
•
personnel have the technical knowledge and tools required to do the
necessary work.
•
Warning stickers must not be removed, as then you and other people
cannot be aware of dangers and may be injured.
1.4 Environment
Obsolete devices contain valuable recyclable materials that should be sent
for recycling.
Send to suitable collection points, separately from residual waste.
The modular construction of the printer enables it to be easily disas-
sembled into its component parts.
Send the parts for recycling.
Take the electronic circuit boards to public waste disposal centers or to
the distributor.
1.5 Technical Data
Cutter
for printer type
Cutting length
Cut frequency
Power Supply
!
Attention!
The minimum cut length is depending on the media, in particular its
adhesive characteristics.
Perform preliminary tests. Test the media too, if the media is
very hard, very flexible or very thin.
EOS2
EOS2
mm
1/min
Cutter connector of the printer
EOS5
EOS5
≥ 10
≤ 200
6