Cisco NCS 4200 Series Manual de configuração - Página 13
Procurar online ou descarregar pdf Manual de configuração para Router de rede Cisco NCS 4200 Series. Cisco NCS 4200 Series 36 páginas. 1 port oc-48/ 4 port oc-12/oc-3 + 12 port t1/e1 + 4 port t3/e3 cem interface module configuration guide, cisco ios xe fuji 16.7.x (cisco ncs 4200 series)
Também para Cisco NCS 4200 Series: Manuais de configuração (30 páginas)
Imprimir página
Configuring SDH
tug-2 5 payload VC11
tug-2 6 payload VC11
tug-2 7 payload VC11
end
When you configure mode VC-1x, seven TUG-2 payloads are created. TUG-2 payloads can be of two
Note
types, VC-11 and VC-12. Default for TUG-2 payload mode is VC-11.
TUG-2 payload VC-11 can be configured as VC or T1 and the range is 1 to 4.
TUG-2 payload VC-12 can be configured as VC or E1 and the range is 1 to 3.
Configuring AU-4 — TUG-3 — TUG-2 — VC-11 — T1
To configure AU-4 — TUG-3 — TUG-2 — VC-11 — T1:
enable
configure terminal
controller sdh 0/0/16
rate stm4
au-4 1
mode tug-3
tug-3 1
mode vc1x
tug-2 1 payload vc11
t1 1 cem-group 10 unframed
vc 1 overhead v5 2
interface cem 0/0/16
cem 100
xconnect 2.2.2.2 10 encapsulation mpls
end
Note
Overhead v5 has to be matched with the peer end.
Configuring AU-4 — TUG-3 — TUG-2 — VC-12
Use the following commands to configure AU-4 — TUG-3 — TUG-2 — VC-12:
enable
configure terminal
controller sdh 0/0/16
rate stm4
au-4 1
mode tug-3
tug-3 1
mode vc1x
tug-2 3 payload vc12
e1 1 cem-group 10 unframed
vc 1 overhead v5 2
end
Overhead v5 should match with the peer end.
Note
1 port OC-48/ 4 port OC-12/OC-3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco
Configuring Modes under AU-4 Mapping
IOS XE Fuji 16.7.x (Cisco NCS 4200 Series)
13