Cisco Nexus 7000 Series Manual de instruções de instalação - Página 16

Procurar online ou descarregar pdf Manual de instruções de instalação para Router de rede Cisco Nexus 7000 Series. Cisco Nexus 7000 Series 39 páginas. Switch chassis
Também para Cisco Nexus 7000 Series: Manual de referência (2 páginas), Referência (34 páginas), Manual de instalação (18 páginas), Configuração (8 páginas), Manual de configuração (28 páginas), Manual de início rápido (10 páginas), Manual de início rápido (29 páginas), Manual de instruções de substituição (14 páginas), Manual de instruções de substituição (21 páginas), Manual de instalação (16 páginas), Manual de resolução de problemas (10 páginas)

Installation

The following sections describe the procedures for mounting the chassis in a 19-inch equipment rack

with two or four mounting posts. Before proceeding, review the guidelines and recommendations in

the section "Prerequisites" on page 7 to protect your safety, to maintain sufﬁcient clearance around

the rack during and after the installation, and to ensure proper airﬂow through the chassis after the

installation.

Warning

perform.

Some equipment racks provide a power strip along the length of one of the rear mounting strips. If

your rack has this feature, we recommend that you fasten the brackets and install the interface

processor end of the chassis at the opposite side of the rack.

The two brackets are identical. The inner side of each bracket has a ledge at the bottom to support

the undersides of the chassis, and shielding to provide electrical isolation between the chassis and

the rack. A ﬂange on the front of each bracket provides ﬁve mounting holes at the top, and three at

the bottom. Mount the bracket with the ﬂange in front of the rack post, and with the inner (shielded)

side facing the center of the rack. The ledge should be at the bottom of the bracket. (See Figure 9.)

Figure 9

16 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions

To avoid potentially serious bodily injury, this procedure requires two or more people to

Positioning a Bracket

Flange

Rack post