Cisco RV160W Manual de início rápido - Página 3

Procurar online ou descarregar pdf Manual de início rápido para Router de rede Cisco RV160W. Cisco RV160W 13 páginas.

Guidelines for Mounting the Router on a Wall

When choosing a location for mounting the router on a wall, consider cable

limitations and wall structure.

• Mount the router with the front panel facing upward. Make sure to mount

the router low enough so that you can see the LEDs.

• Make sure that the power supply rests on a horizontal surface such as

the floor or a table. If the power supply is not supported, the strain on

the power adapter cable could cause it to disconnect from the router.

• Do not install the router or its power supply next to a heat source of any

kind, including heating vents.

You can mount the router on a hollow wall or a wall stud. To mount the

router, follow these steps:

Position the router on the wall to determine where to attach the two

TEP

mounting screws. Drill two pilot holes at approximately 109 mm

apart.

Insert a screw into each hole, leaving a gap between the surface

TEP

and the base of the screw head of 1 to 1.2 mm.

Place the router wall-mount slots over the screws and slide the

TEP

router down until the screws fit snugly into the wall-mount slots.

Insecure mounting might damage the router or cause injury.

ARNING

Cisco is not responsible for damages incurred due to insecure

wall-mounting.

For safety reasons, please ensure that the heat dissipation

ARNING

holes are facing sideways.

Cisco RV160W Router Quick Start Guide