CAB e4 Manual do operador - Página 11
Procurar online ou descarregar pdf Manual do operador para Impressora CAB e4. CAB e4 18 páginas. Barcode/label printer the economy class
Também para CAB e4: Manual do operador (18 páginas)
Imprimir página
4
Operation
4. Operating Functions
Normal mode
FEED
A label is fed forward.
PAUSE
The current print job has paused, MEDIA flashing.
Paused print job resumed.
CANCEL
The current print job has been stopped.
Continue printing after rectifying fault.
System mode
i
In system mode, the printer cannot accept any commands from the PC.
Activate system mode:
Press the CANCEL button and keep it pressed for four seconds. The three flashing LEDs indicate that the printer
is in system mode.
Exit system mode:
System mode is exited automatically if no command is input within four seconds of starting.
Self-test
1.
Press the PAUSE button in system mode.
2.
The three LEDs flash.
The device prints a configuration report.
3.
The three LEDs are continually lit.
The printer is in standard status again.
4.
The following information is printed out:
-
List of fonts
-
Hardware configuration and status
-
DIP switch settings
-
Label parameters
-
Firmware version
Calibrating the media sensor
The media sensor must be recalibrated when a new type of media is loaded.
1.
Press the FEED button in system mode.
2.
The three LEDs flash.
The printer advances the media about 200 mm.
3.
The three LEDs are continually lit.
The printer is in standard status again.
Reset
1.
Press the CANCEL button in system mode.
2.
The following parameters are reset to the factory settings:
-
Label parameters
-
Heat level
-
Print speed
-
Other special settings
3.
The three LEDs light up.
The printer is in standard status.
i
The printed label counter cannot be reset.
11