Ace 73-250 Manual de instruções e manutenção - Página 2
Procurar online ou descarregar pdf Manual de instruções e manutenção para Filtro de ar Ace 73-250. Ace 73-250 4 páginas. Associated equipment portable air cleaner instruction & maintenance manual
Imprimir páginaTHEORY OF OPERATION
This unit is a lightweight, portable air cleaner
ernploying two thermally protected, high
performance, flow thrcugh vacuum molors
producing very high velocity arrflow through the unit
'By
utilizing a large (2 %") inlet plus a variety of
collectrng nozzles and fittings flne solid padiculate
maierial;nd smoke maY be removed from the air by
the filter media.
An initial spark trap collects large partioles before
thev reach the filter. An easy to emPty tray is
attachecl to the front cover to enable the removal of
lhe larqe garticles collected by the spark trap without
removing the filter. This tap further isolates the filter
from sparks in the case of a weld,ng operatlon.
A"cloooed" fllter liqht. actuated by a d ferential
oress;; switch is-an integral part ofthe unit When
ihe filters becote clogged, the light will illuminate'
At this point, the filter should be changed
GENERAL MAINTENANCE
ONLY QUALIFIED SERVICE TECHNICIANS
SHOULD MAKE REPAIRS TO THIS UNIT'
DO NOT REPLACE THESE MOTORS WITH
MOTORS OTHER THAN THOSE RECOMMENDED
BY THE MANUFACTURER,
UNPACKING
Carefully inspect the unit for concealed damage that
mav have occuned during shipping and handling lf
ani damage is found, immediately contact the
Fr;ioht comoanv. Make sure there are no dents in
the iousing, as they might prevent the filter from
sliding into the unit smoolhly lf there is no evidence
of da;aqe, remove the end cover by releasing the
two rubGr latches. Removal of the front cover will
allow inspection of the inside of the unit
After unpacking the machine, check to see that the
following parts and accessories are presenl:
1) - 10'Flexible Hose
1) - Coupling
1i - Flexibbtetal Hose/Magnetic Base comPonent
Parts. (See Figlre #2 For Individual Parts
Included)
1) - Slot Nozzle
1) - Filter
INSTALLATION (See Fisure #1)
1. lnsert the filter, gasketfrrst, into the unit. Then
Dlace the rubberthen steelwashers over the
threaded rod. Tighten the wing nut down so that
the filter is sealed and will not rotate.
2. Reolace the front cover/spark trap assembly and
re-iatch the cover using the rubber latches.
3. Connect the unit to the power source and test
the operation of the unit by turning it ON with the
On/Off switch. Should the motors not start, or
should the machine make unusual noises'
immediatelv turn the machine off and seek
trained maintenance personnel. Once the test is
complete, turn the unit back OFF
4. Attach the hose to the inlet
5. Assemble the flexible metal hose and nozzle per
Figure #2.
6
Connect the hose/nozzle comolnatlon
assembled in Step 5 above to the machinewith
the 10'flexible hose and the supplied coupling
This comDletes the basic assembly ofthe unit
Deoendinq upon the accessories ordered and the
looistica oithe wo* place, lhe installation
oo'nfiguration maY vary.