Cisco 1700 series Manual de configuração - Página 16

Procurar online ou descarregar pdf Manual de configuração para Ponto de acesso sem fios Cisco 1700 series. Cisco 1700 series 25 páginas. Secure firewall management center
Também para Cisco 1700 series: Manual de informações sobre conformidade regulamentar e segurança (45 páginas), Manual (15 páginas), Nota de aplicação (41 páginas), Resolução de problemas de hardware (12 páginas), Manual de síntese (13 páginas), Configuração (34 páginas), Manual (5 páginas), Manual de início rápido (6 páginas), Manual de instalação do hardware (46 páginas)

Imprimir página
Cisco 1700 series Manual de configuração
Connecting a Cisco WIC-1ENET Card to the LAN
Respond to the prompt as follows:
b.
Would you like to enter basic management setup? [yes/no]: no
First, would you like to see the current interface summary? [yes]: no
Enter the host name of the router as follows:
c.
Configuring global parameters:
Enter the enable secret password as follows:
d.
The enable secret is a password used to protect access to
Enter the enable password as follows:
e.
Enter enable password: password
Enter the virtual terminal password as follows:
f.
The virtual terminal password is used to protect
Respond to the prompts as follows:
g.
Configure SNMP Network Management? [yes]: no
h.
Enter the IP address and subnet mask as follows:
Configuring interface parameters:
Do you want to configure Ethernet0
IP address for this interface: ipaddress
Do you want to configure FastEthernet0
The following configuration command script was created:
hostname Router
enable secret 5 $1$ANpR$LYOj7mFpk1TE7SSAXDgVA/
enable password password
line vty 0 4
password password
no snmp-server
!
!
ip routing
no bridge 1
!
Configuring the Interface
16
Enter host name [Router]: hostname
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: password
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
access to the router over a network interface.
Enter virtual terminal password: password
Configure IP? [yes]: yes
Configure IGRP routing? [yes]: yes
Your IGRP autonomous system number [1]: 1
Configure bridging? [no]: no
Configure IP on this interface? [yes]: yes
Subnet mask for this interface [255.0.0.0] : netmask
Class X network is x.x.x.x, x subnet bits; mask is /x
interface? [yes]: yes
interface? [yes]: no
78-11422-03