Cisco 500 Series Guia de início rápido - Página 9

Procurar online ou descarregar pdf Guia de início rápido para Ponto de acesso sem fios Cisco 500 Series. Cisco 500 Series 13 páginas. Stackable managed switches
Também para Cisco 500 Series: Manual de informações de segurança (42 páginas), Manual (4 páginas), Manual de início rápido (21 páginas), Ficha de dados (5 páginas), Manual do utilizador (4 páginas), Manual do utilizador (6 páginas), Manual do utilizador (46 páginas), Manual (40 páginas), Manual de Administração (48 páginas), Manual (24 páginas), Resolução de problemas e manutenção (15 páginas), Manual de referência rápida (7 páginas), Manual de início rápido (25 páginas)

If it fails, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:

Request timed out.

Possible Cause of Failure

Devices Can't Connect using Wi-Fi

• Complete the Setup Wizard. The Wi-Fi radio on the device is turned off

by default, and the Setup Wizard activates it. For users who do not wish

to use the Setup Wizard, log into the device using a Category 5e

Ethernet cable, and activate the Wi-Fi radio manually. See the

Administration Guide for details on activating the Wi-Fi radio.

No Power

• Power up the switch and your computer if they are turned off.

• Make sure your PoE switch is powered on and the lights indicate that

you have a link. See

• Verify that the devices on your network are not plugged into a

switchable outlet.

Bad Ethernet Connection

• Check the state of the indicator lights. See

Installation" on page

• Check the Ethernet cable to ensure that it is firmly connected to your

devices. Devices connected by the Ethernet cable can include the WAP

device, and routers, any switches, and your computer.

• Verify the connected switch has auto-negotiation enabled. The access

point and the switch need the same negotiation parameters set.

Bad Image

After a new firmware installation, if the Power light is flashing quickly,

contact system support; see

Incorrect IP Address

The most likely cause of connectivity failure is an incorrect IP address. The

Web browser may be pointed to the wrong IP address, or your computer

may be configured with an IP address that is not in the same subnet as the

device.

Cisco Small Business WAP500 Series Wireless Access Point

"Verifying the Hardware Installation" on page

"Where to Go From Here" on page

"Verifying the Hardware

11.