Cisco AIR-AP1142N-E-K9 Manual de iniciação - Página 22
Procurar online ou descarregar pdf Manual de iniciação para Ponto de acesso sem fios Cisco AIR-AP1142N-E-K9. Cisco AIR-AP1142N-E-K9 37 páginas. Autonomous access point
Imprimir página
Table 3
System Power Settings (continued)
Power Source
802.3af-compliant switch that does
not support Cisco inline power
(non-Cisco switch)
AC power adapter
1.
Check the release notes for your power sourcing equipment to determine which Cisco IOS version supports Cisco Intelligent Power
Management. For some PSEs, support for Cisco Intelligent Power Management might not be available yet.
2.
MAC address is the 12- character hexadecimal address of the switch port to which the access point is attached. The MAC address format is
HHHH.HHHH.HHHH.
Click Apply. The access point reboots configured with the power settings you specified.
Step 6
You might have to refresh your browser screen to see the current status indicating that the
Note
access point radios are enabled.
Finding More Troubleshooting Help
If you are still experiencing difficulty, before contacting Cisco, look for a solution to your problem in
this guide or the troubleshooting chapter of the hardware installation guide for the access point you
are using. These, and other documents, are available on Cisco.com. Follow these steps to access and
download these documents:
Open your web browser and go to http://www.cisco.com.
Step 1
Click Products & Services. A pop-up window appears.
Step 2
Click Wireless. The Wireless Introduction page appears.
Step 3
Step 4
Scroll down to the Product Portfolio section.
Under Access Points, click Cisco Aironet 1140 Series. The Cisco Aironet 1140 Series
Step 5
Introduction page appears.
Scroll down to the Support window and click Install and Upgrade. The Cisco Aironet 1140
Step 6
Series Install and Upgrade page appears.
Step 7
Click Install and Upgrade Guides. The Cisco Aironet 1140 Series Install and Upgrade Guides
page appears.
22
System Power Settings
No configuration requirement
No configuration requirement
Switch Status