Argent Cables HD DVB-T MODULATOR Manual do utilizador - Página 8
Procurar online ou descarregar pdf Manual do utilizador para Modulador Argent Cables HD DVB-T MODULATOR. Argent Cables HD DVB-T MODULATOR 10 páginas. 1080p dvb-t modulator with hdmi loop through + rf output + rf input
Imprimir página8.- Input 12V DC power adapter (included).
3.2
Starting
After connecting the power to the instrument, the message "Initial...." "Please Wait..."
1.-
appears for 37 seconds.
Then the message "Keyboard Locked" appears. To access to the configuration menus
2.-
the user has to enter a password.
Press ENTER
3.-
The field "Enter Password" appears. Enter the access code. (By default: 0000).
4.-
Press ENTER
5.-
The field "Network Setting" appears, this is the first option on the configuration menu.
6.-
3.3
Configuration menu
1.- Frequency: It sets the frequency value for the output signal. Important: Check that the
selected frequency is not already being used by a current television distribution channel.
2.- RF Level Adj: It adjusts the power level of the output signal, in dB units. Its range from 0 to -30
dB.
3.- Bandwidth: Channel bandwidth. (6, 7 , 8 , 7 - 8 MHz).
4.- FFT Carriers: Signal transmission mode. (2K, 8K).
5.- Guard Interval: Safety signal margin. (1/4, 1/8, 1/16, 1/32).
6.- Constellation:
Constellation type used to transmit signal(QPSK,16QAM, 64QAM).
7.- Code Rate: Available values are (1/2, 2/3, 3/4, 5/6, 7/8).
8.- Video Output: Video encode. H.264 of the video output.
9.- Audio Output: Audio encode. Selection between MPEG-2 and AAC
10.- Video Bitrate: Select video bit rate(2,4,6,8,10,12 Mbit/S).
11.- Audio Bitrate: Bitrate to encode the audio. Available values are between 192 kbit/s.
12.- Service Name: Service name edit.
13.- Provider Name: Service provider name edit.
14.- Service ID: Service ID edit.
15.- LCN: It specifies the index for the service sorting on the digital terrestrial television
receiver. Values are between 1 and 999.
16.- Country: Country selection for LCN sorting.
17.- Original Net ID: Identifier of the original network. It is the number to identify the network
from where the signal comes.
18.- Network ID: It is the number that identifies the network where the signal is distributed.
19.- Network Name: Network name edit.
20.- TS ID: It is the transport stream identifier.
21.- NIT Version: Network Information Table version. In some countries it should match with
other tables version received from the receiver.
22.- Information: It shows the firmware version installed in the instrument. This option is not
editable.
23.- Apply Setting: It saves the current configuration on the non-volatile memory of the
.
.
- 7 -