Cisco Aironet 1570 Series Manual de encomenda - Página 8

Procurar online ou descarregar pdf Manual de encomenda para Ponto de acesso sem fios Cisco Aironet 1570 Series. Cisco Aironet 1570 Series 17 páginas. Outdoor access point
Também para Cisco Aironet 1570 Series: Manual de instalação do hardware (10 páginas)

Imprimir página

Power over Ethernet

The AP1572EAC can be powered over the Ethernet connection. Power can be sourced directly from an
appropriately powered Universal Power over Ethernet (UPoE) switch port or from the inline power injector listed in
Table 12.
Table 12.
Part Number
AIR-PWRINJ1500-2=
You must also specify the country type AC power cord for the power injector.
The Aironet 1570 Series access points use a standard RJ-45 Ethernet connector. Cisco does not provide an
Ethernet cable for the 1570 Series. You will need to source an outdoor-rated, Category 5 or better Ethernet cable
and shielded RJ-45 connectors from a local supplier. A liquid-tight gland is provided with the access point to seal
this cable entry point from weather.

DC Power

The Aironet 1570 Series access points support power from an external DC power supply. Check the
the associated voltage, current range, and power consumption. A DC terminal block is included with the
AP1572EAC for this purpose. While not common, the cable-powered AP1572IC and AP1572EC can also use DC
power. For that, an accessory kit is available to provide DC terminal block connectors
section/table). Note that these DC connectors are specifically for the Aironet 1570 Series and should not be
interchanged with DC terminal blocks for the previous AP1520, AP1550, or 1530 models. When using DC power,
please consult the

SFP

All the Cisco Aironet 1570 Series Outdoor Access Points support fiber backhaul. The SFP is built into the AP, but
the mechanical interface is external to the AP. A special SFP adapter/gland kit is needed to interface the fiber
cable to the AP. Table 13 lists the SFP and the adapter/gland accessory kit, and Figure 2 illustrates them.
Table 13.
Powering Option
AIR-ACC15-SFP-GLD=
GLC-LX-SM-RGD=
GLC-SX-MM-RGD=
© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Power Injector for Use with PoE
Description
1520/1550/1570 Series Power Injector; for indoor environments only
hardware installation guide
SFP Components for use with AP1570
Description
Accessory, SFP external Gland/Adapter, bag of 5 units
1000BASE-LX single-mode Rugged SFP
1000BASE-SX multi-mode Rugged SFP
for instructions on how to correctly assemble the connector.
data sheet
for
(see the accessories
Page 8 of 17