Argent Data Systems ADS-SR1 Manual do utilizador - Página 13

Procurar online ou descarregar pdf Manual do utilizador para Repetidor Argent Data Systems ADS-SR1. Argent Data Systems ADS-SR1 20 páginas. Simplex repeater

Imprimir página

Radio Interface Settings

##11<nn> – Set Transmit Audio Level

Sets the transmitted audio level, from 00 to 99. Avoid using low numbers,

as this decreases sound quality. Set the level first using the DIP switches, and

then use this setting as a fine adjustment. Default is 99.

Example: ##1150 – Audio level 50%

##107<n> – Set Audio Input Gain

If the audio level from the radio is too low, this setting can be used to

increase the gain in software. ##1070 sets 1x gain, ##1071 is 2x, and ##1072 is 4x.

Note that this setting does not affect the VOX threshold. The unit must be reset

for this setting to take effect. Default is 1x gain.

Example: ##1071 – Sets 2x gain

##92<nn> - Transmit Delay Time

Digital radios, or radios with slow transmit turnaround, may require an

extra delay between PTT and the start of a transmission. This option sets the

transmit delay in 1/10 second units. Default is 0.5 seconds.

Example: ##9220 – Repeater will wait 2.0 seconds between PTT and first audio

##77<1/0> - Courtesy Tone Delay On/Off

Some radios produce a beep from the local speaker at the end of each

outgoing transmission that can cause the repeater to get stuck in a continuous

transmission cycle. Enabling this option causes the repeater to ignore audio for

one second after each transmission. Default is off.

Example: ##771 –Enable courtesy tone delay

##109<n> – COR / Squelch Input Mode

Some radios provide a 'carrier operated relay', 'carrier operated switch',

or other squelch output. Set this option to 0 for VOX operation, 1 for an active-

high input, and 2 for an active-low input. Default is VOX mode.

Example: ##1091 – Enable squelch input, active high

##79<nn> - Squelch Tail Suppression Time

If your radio has a slow squelch, you may hear a static crash at the end of

each repeated transmission. Set this option in 1/75 second units to reduce or

eliminate this noise. Default is zero.

Example: ##7910 – Repeater will ignore last 10/75 (0.133) second of each transmission