Cisco ASR1006 - ASR 1006 Modular Expansion Base Manual de instalação do hardware - Página 3
Procurar online ou descarregar pdf Manual de instalação do hardware para Ponto de acesso sem fios Cisco ASR1006 - ASR 1006 Modular Expansion Base. Cisco ASR1006 - ASR 1006 Modular Expansion Base 47 páginas. Lightweight access points
Também para Cisco ASR1006 - ASR 1006 Modular Expansion Base: Manual de implantação (40 páginas)
Imprimir página
• Screwdrivers: Number 2 Phillips screwdriver and 3/16-inch flat-blade screwdriver
• Grounding lug and wires
• The rack-mount and cable-management kit:
Four 19-inch rack-mount brackets (front and rear rails) and two cable-management brackets
–
Three sets of screws: one set for front rack-mount brackets (black screws), another set for rear rack-mount brackets,
–
and a set for the cable-management brackets (package with four screws)
Prepare for Equipment Shelf or Tabletop Installation
For a equipment shelf or tabletop installation, verify the following before installing the router:
• The router is off the floor and has adequate ventilation.
• An adequate chassis ground (earth) connection exists for the router.
• The router needs at last 3 inches (7.62 cm) of clearance at the inlet and exhaust vents (sides of router).
• The router needs 19 inches (48.26 cm) of clearance at the front and rear to allow for field-replaceable unit replacement or
installation, or to access cables or equipment.
• The shared port adapters are installed. If shared port adapters are not installed, then the slots must not be empty. Use filler
panels for an empty slot.
Prepare for Rack-Mount Installation
Before you begin the rack-mounting tasks:
• Decide whether or not you want to front rack-mount or rear rack-mount the chassis
• Decide whether or not you want to attach cable-management brackets to your chassis.
If you install cable-management brackets, make certain that the chassis is installed in the equipment rack first.
Note
• Decide if a two-post or four-post rack-mount will be used.
3
Rack-Mount the Router
This section provides information for rack-mounting the router.
Attach the Rack-Mount Brackets—Chassis Front-Mounted
To install the rack-mount brackets on a Cisco ASR 1006 Router for a front rack-mount configuration, follow these steps:
Locate the threaded holes in the front sides of the chassis. Make certain that you hold the front rack-mount bracket
Step 1
with the ear and holes facing outward and towards the front of the chassis.
Step 2
Align the rack-mount bracket to the side of the router. Depending on which set of rack-mount bracket holes you choose
to use to attach the rack-mount bracket to the router, the chassis will either be recessed in the rack or protrude from
the rack.
Step 3
Position the front rack-mount bracket top hole with the chassis first top hole behind the side vent holes as shown in
Figure
1.
3