ACU-RITE 01645 Manual de instruções - Página 10

Procurar online ou descarregar pdf Manual de instruções para Estação meteorológica ACU-RITE 01645. ACU-RITE 01645 20 páginas. Weather center

3-in-1 Sensor Installation Guidelines

INSTALLATION HEIGHT

off the ground, in an open area. Higher is better for wind measurements - the

National Weather Service recommends 33 feet high!

MOUNTING OPTIONS

onto wooden posts or surfaces that are 2x4 or larger. The sensor can also be

mounted directly to common 3/4"

steel pipe (available at hardware

stores and home centers).

LEVEL INSTALLATION

bubble level (not included) to ensure

level installation for accurate wind

measurement.

Top or Side Mount

1. Insert the mounting base into the

hole on the bottom of the sensor.

2. Use one of the screws included

in the hardware bag to fasten

the lower sensor housing to the

mounting base.

3. Fasten mounting base to a post or railing

using 2 screws.

Pipe Mount

1. Insert pipe or similar item all the way into

the hole on the bottom of the sensor. Note:

Mounting base is not used.

2. Use one of the screws included in the

hardware bag to fasten the lower sensor housing securely to the pipe.

The 3-in-1 sensor is now ready to use.

Basic Setup is Complete

The 3-in-1 sensor will now synchronize with the display. It may take a few minutes

for synchronization to complete. If both or one of the units appear to be functioning

improperly, please refer to the troubleshooting section.

Mount the sensor at a minimum height of 5 feet (1.5 meters)

The included mounting bracket it designed to screw directly

Use a

Top Mount

Side Mount

Pipe Mount

Do not install during

electrical storms.

Do not place pipe

or sensor near

electrical lines or

electrical equipment.