Argo 387006118 Dados técnicos e manual de serviço - Página 10

Procurar online ou descarregar pdf Dados técnicos e manual de serviço para Ar condicionado Argo 387006118. Argo 387006118 19 páginas. Indoor unit, split system air conditioner

Imprimir página

■ HIGH POWER

Raises the power but remains in the same operating mode.

This function is set with the HIGH POWER button on the remote

controller.

(It is set regardless of the temperature and fan speed settings.)

● HIGH POWER operation from the remote controller

The unit operates at maximum output for 15 minutes,

regardless of the desired temperature.

The fan speed is 1 step above "High."

Frequency

MAX

15 min.

Start

NOTE

• When HIGH POWER operation ends, the unit operates at low

Hz for 5 minutes, regardless of the thermostat OFF conditions.

• When in DRY mode, operation is in the cooling zone.

• When in HEAT mode, defrosting does not occur during HIGH

POWER operation.

• If HIGH POWER is set while defrosting is in progress, HIGH

POWER operation begins after defrosting ends.

• HIGH POWER operation cannot be set from the remote

controller when the unit is stopped.

• HIGH POWER operation and ECONOMY operation cannot be

used at the same time. The function set last takes priority.

■ ECONOMY

• When ECONOMY operation is set, the temperature and fan

speed settings will be adjusted automatically to allow

comfortable sleep.

• When ECONOMY operation is set, "

remote controller.

● COOL and DRY modes

• The indoor unit fan speed is automatically lowered for quiet

operation.

• The temperature setting is raised by 1°C one hour after

ECONOMY operation is set.

● HEAT mode

• The indoor unit and outdoor unit fan speeds are

automatically lowered for quiet operation.

• The temperature setting is lowered by 3°C one hour after

ECONOMY operation is set.

In addition, the temperature setting is lowered by 4°C after

two hours have passed.

Time

5 min.

End

mark" appears on the

■ Lamp colors

Operation lamp

HEAT operation : Red

DRY operation : Orange

COOL operation : Green

TIMER lamp

■ ON timer operation

• Operation starts when the time set for the ON timer is reached.

When a time is set, the TIMER lamp illuminates.

• The below comfort timer programming is performed.

A comfort time is calculated from the set temperature and the

room temperature, either 60 minutes prior or 30 minutes prior to

the set ON timer time, and operation is started in advance of

the set ON time. (The indoor fan speed is "Medium.")

[COOL]

Indoor temperature – Set temperature = Temperature difference

[HEAT]

Set temperature – Indoor temperature = Temperature difference

Temperature difference (°C)

12 < Temperature difference

6 < Temperature difference

NOTE

This function does not operate if the ON timer standby time is

less than 30 minutes.

■ OFF timer operation

• Operation stops when the time set for the OFF timer is

reached.

When a time is set, the TIMER lamp illuminates.

■ Timer backup

• If the indoor unit is unable to receive the timer time-end signal

when the ON or OFF time is reached, then timer time-end

occurs according to the indoor unit backup timer within

approximately 26 minutes.

• Operation stops if there are no operator controls for 25 hours or

longer after unit operation switched from OFF to ON by use of

ON timer operation.

: Green

Advance start time (min.)