Cisco Meraki MR20 Manual de instalação - Página 7
Procurar online ou descarregar pdf Manual de instalação para Ponto de acesso sem fios Cisco Meraki MR20. Cisco Meraki MR20 12 páginas.
Imprimir página
Mount the MR20
Attach the MR20 to the Mount Cradle
The MR20 attaches to the mount cradle with two tabs on the cradle that insert into the MR20, and is secured to the
cradle using one screw.
To attach the MR20 to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle.
Since the cradle is already mounted to the wall, guide the MR20 towards the top tab and insert the top tab into the
MR20's slot.
Then adjust the MR20 to guide the MR20's bottom slot into the cradle's bottom tab until it clicks into place. Once in
place, the MR20 should be secured to the cradle by using one of the included screws in the cradle's bottom tab.
Power the MR20
If mounting to an electrical junction box, feed the Ethernet cable through the cable access hole in the mount cradle. If
mounting to a wall or ceiling, the Ethernet cable will feed from behind the MR20. The
"Power Source
Options" section of
this document lists the different powering options and their unique characteristics.
Mount the MR20
Attach the MR20 to the Mount Cradle
(This section applies to wall and/or solid ceiling, drop ceiling or electrical junction box mount
where you have already installed the mount cradle.)
The MR20 attaches to the mount cradle with two tabs on the cradle that insert into the MR20, and is secured to the
cradle using one screw.
To attach the MR20 to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle.
Since the cradle is already mounted to the wall, guide the MR20 towards the top tab and insert the top tab into the
MR20's slot.
Then adjust the MR20 to guide the MR20's bottom slot into the cradle's bottom tab until it clicks into place. Once in
place, the MR20 should be secured to the cradle by using one of the included screws in the cradle's bottom tab.
7