Cisco Meraki MR84 Manual de instalação do hardware - Página 5

Procurar online ou descarregar pdf Manual de instalação do hardware para Ponto de acesso sem fios Cisco Meraki MR84. Cisco Meraki MR84 13 páginas.

installation.

3.1 Configure Your Network in Dashboard

Meraki recommends that you add your MR84 to a network in Dashboard

before mounting it in the field. The following is a brief overview only of the

steps required to add an MR84 to your network. For detailed instructions

about creating, configuring and managing Meraki wireless networks, refer

to the Meraki Cloud Controller Manual

(cisco.meraki.com/support/#documentation).

1. Login to http://dashboard.meraki.com. If this is your first time, create a

new account.

2. Find the network to which you plan to add your nodes or create a new

network.

3. Add your nodes to your network. You will need your Meraki order number

(found on your invoice if you ordered directly from Meraki) or the

serial number of each node, which looks like Qxxx-xxxx-xxxx, and is

found on the bottom of the unit.

4. Finally, go to the map / floor plan view and place each node on the map

by clicking and dragging it to the location where you plan to mount it.

You can always modify the location later.

3.2 Check and Upgrade Firmware

To ensure your MR84 performs optimally immediately following installation,

Meraki recommends that you facilitate a firmware upgrade prior to

mounting your MR84.

1. Attach your MR84 to power and a wired Internet connection.

2. The MR84 will turn on and the LED will glow solid orange. If the unit does

not require a firmware upgrade, the LED will turn solid white within 30

seconds.

* If the unit requires an upgrade, the LED will cycle rainbow until the

upgrade is complete, at which point the Power LED will turn solid white. You

should allow about an hour for the firmware upgrade to complete,

depending on the speed of your internet connection.