Cisco WAP121 Manual de início rápido - Página 8

Procurar online ou descarregar pdf Manual de início rápido para Ponto de acesso sem fios Cisco WAP121. Cisco WAP121 13 páginas. Reboot and reset to factory default settings
Também para Cisco WAP121: Revisão (6 páginas), Ficha de dados (7 páginas), Manual de início rápido (13 páginas), Brochura e especificações (4 páginas), Manual (4 páginas), Manual (4 páginas)

Imprimir página
Cisco WAP121 Manual de início rápido
Follow the Setup Wizard instructions to finish the WAP device
S
7
TEP
installation. We strongly recommend you use the Setup Wizard for
the first installation.The Setup Wizard turns on the Wi-Fi radio,
allowing you to connect wirelessly. For advanced configurations,
see the Administration Guide. A link to the Administration Guide is
found in
Congratulations, you can now start using your wireless access point.

Suggested Next Steps

7
In case of an error while installing, try the following troubleshooting
procedures:

Troubleshooting

If you cannot display the configuration utility, you can test the ability of the
computer to communicate with the device by using ping. To use ping on a
computer running Windows:
Verify that the Cisco WAP121 or WAP321 is powered on and the
S
1
TEP
lights indicate the appropriate links.
Locate the device's IP address. While there are different ways to
S
2
TEP
locate your device's IP address, this procedure uses Cisco FindIT.
a.
If you have previously downloaded Cisco FindIT, open Internet
Explorer and launch Cisco FindIT. For more information on
downloading Cisco FindIT, see www.cisco.com/go/findit.
b. In the Cisco FindIT display, place your mouse over the device's
name. The device IP address is displayed along with other
device information.
Open a command window by using Start > Run and enter cmd.
S
3
TEP
At the Command window prompt enter ping and the device IP
S
4
TEP
address. In this example, we pinged 192.0.2.10.
If successful, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128
If it fails, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
Request timed out.
8
"Where to Go From Here" on page
Cisco WAP121 and WAP321 Wireless-N Access Points
11.