Cisco WAP321 Manual

Procurar online ou descarregar pdf Manual para Ponto de acesso sem fios Cisco WAP321. Cisco WAP321 4 páginas. Reboot and reset to factory default settings
Também para Cisco WAP321: Revisão (6 páginas), Ficha de dados (8 páginas), Manual de início rápido (13 páginas), Brochura e especificações (4 páginas), Manual de início rápido (13 páginas), Manual (4 páginas)

Reboot and Factory Default Reset on

WAP121 and WAP321 Access Points

Objective

This article explains how to perform a standard reboot and also how to reset to factory

default on the WAP121 and WAP321 access points. Reboot or restart of the network

device is made when certain changes in the settings need a reboot or if the device is

frozen. Consequences of reboot will result in the deletion of logs in volatile memory.

The configuration settings of the network device gets reflected after the restart. Factory

default reset is used to remove the running/current configuration settings on the

network device and to restore it to the original default settings. Factory default reset is

recommended when the whole device needed to be reconfigured and also in case if

you forget the password and not able to recover by any means such as telnet.

Applicable Devices | Firmware Version

WAP121 | 1.0.3.4

WAP321 | 1.0.3.4

Reset to Factory Default

There are two ways to reset to factory default settings to the factory default

configuration:

Hardware Reset

Factory default reset by web configuration utility

Hardware Reset

Step 1. Hold the Reset button located at the back of the device for approximately ten

seconds with a pin.

The Access Point reloads and is set to the default configuration settings.

Step 2. Launch a web browser, such as Internet Explorer or Mozilla Firefox. Type the

default static IP address 192.168.1.245 in the URL bar and press enter. To reach that

IP address, be sure that your computer is on the 192.168.1.xxx network.

If your network has a DHCP server, then the factory default IP address configuration of the

WAP is DHCP. In the absence of a DHCP server, the access point will fallback to the

(Download

latest)

(Download

latest)