Digitana VCS3 MKII Quad Midi-CV Manual do utilizador - Página 7
Procurar online ou descarregar pdf Manual do utilizador para Equipamento de gravação Digitana VCS3 MKII Quad Midi-CV. Digitana VCS3 MKII Quad Midi-CV 13 páginas.
Imprimir páginaLower Toggle Switches Function
Lower toggle switches allow independent switching of DK/KS control or Midi-CV control of
each of the 3 independent CV input channels of the VCS3(mk2) matrix (Input Ch1, Input Ch2,
and row 16 of the matrix).
As mentioned above, there is also the option to invert CV3 or the DK/KS CV source into
row16 of the matrix via another toggle switch..again adding to the creative possibilities.
Any pattern based or multi-tracking software/hardware sequencer or Midi keyboard will
work with the unit. Software sequencers (eg those used in Cubase etc) allow the drawing of
'envelope shapes' for Midi continuous controller messages. These will then create dynamic
envelopes (eg for velocity, pitchbend, modulation wheel etc.) that can be used for any/all of
CV1-CV4.
The Special 4 EMS pin Cable
CV1-CV4 are also available via the special cable that connects to the unit with 4 EMS patch pins
on one end and mini-din plug on the other. The CV is connected to the tip of the pins only
and is designed to be able to inject CV1-CV4 into any of the Synthi control inputs (ie matrix
columns). Inserting these pins has no affect on the rows and they do NOT route signals from the
rows into the matrix columns, as ordinary pins do. Thus in injecting CV1-CV4 into any column on
the matrix, it does not matter which row you choose to insert them..only the column matters.
The pins are colour coded with green,
blue
and
yellow
corresponding to CV1-CV3 and
black
to
CV4.
The purpose of this cable is that CV1-Cv4 can be used even when control of the synthi input
channels is via the DK/KS (via the toggle switches). So its possible eg to use the VCS3 'normally '
with the DK keyboard or KS etc and still have CV1-CV4 available via the matrix pin cable to
add dynamic envelopes etc created via midi for e.g. filter control, Reverb mix, output channel
level envelopes etc..to create very complex patches.
Creating Patches Using the Unit
It's best to have the Input Ch1 and Input Ch2 pots on the VCS3 set to their maximum value 10.
CV1 enters the AKS matrix via Input ch1 and CV2 via input ch2. Locate the joystick vertical
control scaling Pot on the AKS lower panel and turn it to the 'seq' setting (make sure you
hear the 'click' as the pot switch turns off). Then row 16 of the matrix (marked Joystick
vertical control) carries CV3 instead and the joystick vertical control is disabled.
Remember, CV4 is only available via the black pin of the special EMS pin cable discussed
above.