Argo AW38AL Manual de Instruções - Página 10

Procurar online ou descarregar pdf Manual de Instruções para Ar condicionado Argo AW38AL. Argo AW38AL 12 páginas. Split air conditioner system
Também para Argo AW38AL: Manual de Instruções (12 páginas)

Imprimir página

Air outlet

grille

Sweep function

The flap starts moving up and down to deliver air

over the sweep range.

• The flap automatically closes when the unit is off.

NOTES

• During the heating operation, the fan speed

will be very low and the flap will be in the

horizontal position (position 6 ) until the air

being blown out of the unit begins to warm.

Once the air warms up, the flap position and

fan speed change to the settings specified

with the remote control.

CAUTION

• Use the FLAP button on the remote control to adjust

the position of the flap. If you move the flap by hand,

the factual flap position and the flap position on the

remote control may no longer match. If this should

happen, shut off the unit, wait for the flap to close,

and then turn on the unit again; the flap position will

now be normal again.

• Do not have the flap pointed down during cooling

operation. Condensation may begin to form around the

air vent and drip down.

Down

Flap

OPERATION WITHOUT THE REMOTE

CONTROL UNIT

If you have lost the remote control unit or it has troubles, follow

the steps below.

1. WHEN THE AIR CONDITIONER IS STOPPED

If you want to turn on the air conditioner push the MODE button

with a pen to select the desired mode (COOL or HEAT).

NOTE

The air conditioner will start in automatic fan speed and flap

sweep operation. The temperature setting is 22°C for cooling

mode and 26°C for heating mode.

2. WHEN THE AIR CONDITIONER IS RUNNING

If you want to turn off the air conditioner push the MODE button

with a pen until the COOL or HEAT lamp is turned off.

NOTE

Power failure during operation.

In the event of power failure, the unit will stop. When the power

is resumed, the unit will restart automatically after 3 minutes.

CARE AND CLEANING

WARNING

For safety, be sure to turn the air conditioner off and also to

disconnect the power before cleaning.

Do not pour water on the indoor unit to clean it. This will damage

the internal components and cause an electric shock hazard.

CASING AND GRILLE (INDOOR UNIT)

Clean the casing and grille of the indoor unit with a vacuum cleaner

brush, or wipe them with a clean, soft cloth.

If these parts are stained, use a clean cloth moistened with a mild

liquid detergent.

When cleaning the grille, be careful not to force the vanes out of

place.

The air intake grille can be removed in order to wash it

with water.

CAUTION

Never use solvents, or harsh chemicals when cleaning the indoor

unit. Do not wipe the plastic casing using very hot water.

Some metal edges and the vanes are sharp and may cause

injury if handled improperly; be especially careful when you

clean these parts.

The internal coil and other components of the outdoor unit must

be cleaned every year. Consult your dealer or service centre.

Operation

selector