Cisco TANDBERG Quick Set C20 Instalação - Página 5
Procurar online ou descarregar pdf Instalação para Sistema de conferência Cisco TANDBERG Quick Set C20. Cisco TANDBERG Quick Set C20 6 páginas.
Imprimir página
1
Waking up the system
If there is no menu on the screen, press Home (
produce it.
Do as follows:
1.
Make sure the monitor has been turned on.
2.
Make sure the remote control has its batteries installed.
3.
Make sure the codec has been turned on.
4.
If the system has just been turned on, give it a couple of minutes to start up.
2
Verifying IP address settings
Go to System Information to verify the IP address:
1.
Navigate to Settings > System Information
2.
When the IP address is automatically assigned from a DHCP server, the network
IP address of the codec is shown on the System Information page.
3.
Press Home (
) to exit.
3
Password protection of the administrator settings
When you access the Administrator settings you may be asked to enter a password.
The administrator password is blank by default. Press OK to proceed. Once the
initial configurations have been set, we recommend that you define an administrator
password.
4
If you need to set a static IP address
Go to IP Settings to set static IP addresses:
1.
Navigate to Settings > Advanced > IP settings.
2.
Set IP Assignment to Static. Press the left arrow key to go back one step
3.
Enter the IP Address, Subnet Mask and Gateway address in the address fields.
4.
Press OK to save the changes, or Cancel to leave without saving.
5.
Press Home (
) to exit.
D1451302
(11983304 as printer firendly version June 2010)
Installing the TANDBERG Quick Set C20
) on the remote control to
Using DHCP
Setting static IP address
5