ACU-RITE 00782 Manual de instruções - Página 3

Procurar online ou descarregar pdf Manual de instruções para Termómetro ACU-RITE 00782. ACU-RITE 00782 4 páginas.

Troubleshooting:

Using the Reset button on the Indoor unit (receiver):

In some unusual occasions, the Indoor unit may be affected by electrical interference and respond

abnormally. In such conditions, press the RESET button on the Indoor Display unit to resume

normal operation. "RESETING" The Display unit should give you the indoor immediately and the

outdoor temperature within 1 minute.

Using the Reset button on the remote sensor (sender) In some unusual occasions, the remote sensor

may be affected by electrical interference and respond abnormally. In such conditions, press the

RESET button (located inside the battery compartment) on the remote sensor to resume normal

operation.

If you press the RESET button on the remote sensor, you MUST press the RESET button on the

Indoor Display unit (receiver) as well.

If or when the Indoor unit display "- - -"continuously in the outdoor window, it maybe that the

remote sensor is out of range or the batteries low. Please put the Remote sensor (sender) close to

the Indoor unit (receiver) or replace the fresh batteries.

Note:

If the Remote Sensor "RESET" button is pressed, or new batteries are installed in the Remote

Sensor, you MUST press the Reset button on the Indoor Display unit (receiver).

FCC Statement:

FCCID: RNE000782TXA1

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Caution: The user is cautioned that changes or modifications made to the equipment without the

approval of manufacturer could void the user's authority to operate this equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.