DigiTech VTP1 Manual do Proprietário - Página 12

Procurar online ou descarregar pdf Manual do Proprietário para Equipamento de música DigiTech VTP1. DigiTech VTP1 15 páginas. Dual vacuum-tube preamp/eq/converter

Imprimir página

PHASE reversal switch

You can invert the phase of the incoming signal. This may be required when you have two mics

coming into both channels of the VTP-1 and the distance between the mics is at a critical point

where they cause frequency cancellation. Flipping the phase of one of the input channels can

overcome the notchy, comb filtering effects caused by multiple mics on a single source.

20 dB PAD switch

This inserts a gain reduction circuit into the signal path from the microphone input. The pad is

inserted before the signal is passed on to the tube and it is used to prevent overload distortion

from high output microphones.

+48V phantom power switch

This switch activates phantom power for condenser microphones on pins 2 and 3 of the XLR mic

input. Connect your microphone to the VTP-1 before turning on the phantom power. This will

prevent high voltage arcing that may damage your mic.

WARNING: Do not connect unbalanced sources to this input. The voltage on these pins

is sufficient to cause damage if connected directly to a transducer.

DIGITAL OUTPUT Section

FORMAT Switch

The FORMAT switch selects between the industry-standard AES/EBU and S/PDIF stereo dig-

ital audio formats. You should set this switch to the same format as the one your receiving

device requires.

SAMPLE RATE Switch

When using the digital output, the VTP-1 becomes the master clock device and as such, deter-

mines the clock frequency (sample rate) for any digital devices connected to it. You have the

choice of 44.1 kHz which is the standard for Compact Disc duplication, and 48 kHz, which is

the sample rate for many DAT machines. If your recorder allows you an option, you are better

off to stay with 44.1 kHz if your recording stands any chance of being duplicated on CD. If

you have recorded a project at 48 kHz and will be putting it out on CD, you will require sam-

ple rate conversion that may effect the sound of your recording.

Your recorder should automatically sense any change in sample rate even when no audio is

present. If it doesn't, you will have to set it manually. You must also ensure that your recorder

is set to synchronize its sample rate to an external digital device.

•••