Cable-Tronix CT-CATTX Manual de instalação - Página 3
Procurar online ou descarregar pdf Manual de instalação para Recetor Cable-Tronix CT-CATTX. Cable-Tronix CT-CATTX 4 páginas. Cat 5 distribution hub and receiver
Imprimir página1. UNPACKING and HANDLING
Each unit is shipped assembled and factory tested. Ensure that all accessories are removed
from the container before discarding packing material
2. MECHANICAL INSPECTION
Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose. If equipment appears to be damaged
or defective please contact your distributor or Cabletronix at 1-610-429-1511 for assistance.
3. PRODUCT DIAGRAM
4. HARDWARE CONNECTIONS
a. Connect Cat 5 cables A1 and B1 to the CT-CATTX's RJ-45 jacks. At the other end of
the same cables connect A1 and B1 to the CT-CATRX. The RCA outputs are used ot
connect to the remote monitor.
b. Insert the power supply connector into the power jacks of both units. Plug the wall
transformer into a power outlet. The power LED should be on and the unit is ready to
use. The CT-CATRX will have 3 LEDs on to indicate continuity of the CAT 5 cable. If
one of the Continuity LEDs is not on there could be a problem with the A cable. Both A
and B cables should be installed for the detector to work properly.
INSTALLATION
3