DigiTech Control One Manual do Proprietário - Página 6

Procurar online ou descarregar pdf Manual do Proprietário para Acessórios DigiTech Control One. DigiTech Control One 8 páginas. Remote foot controller for use with the 2112 sgs, gsp-2101, valve fx and legend ii

Imprimir página

• Control Output - The Control Output is a 5-pin DIN connector (MIDI-type). All control information gen-

erated by the Control One is sent out the Control Output to the 2112 SGS, GSP-2101, Valve FX or Legend

II. The Control One also gets its power from the 2112 SGS, GSP-2101, Valve FX or Legend II down this

cable, eliminating the need for a separate power supply for the foot controller.

IMPORTANT: The Control Output is not a MIDI output, and should not be connected to any-

thing but the dedicated Foot Controller connector on the 2112 SGS, GSP-2101, Valve FX or

Legend II.

• External Continuous Controller Input - This 1/4" jack allows a second continuous control device to be

used with the 2112 SGS, GSP-2101, Valve FX or Legend II. It responds to both control voltage and

resistance pedals (volume-type), and can be used in conjunction with the built-in CC pedal.

Section 2 - Basic Operation

Using the Control One

Following is a basic step-by-step procedure on how to connect and use the Control One with your 2112 SGS,

GSP-2101, Valve FX or Legend II.

• Make sure the power to your 2112 SGS, GSP-2101, Valve FX or Legend II is off.

• Using a standard 5-pin DIN cable (MIDI-type), connect the Control Output to the Foot Controller input

on the rear panel of the 2112 SGS, GSP-2101, Valve FX or Legend II.

WARNING: Do not connect devices other than the Control One to the Foot Controller connector on

the rear panel of the 2112 SGS, GSP-2101, Valve FX or Legend II. This is not a MIDI connection.

Connecting devices other than the Control One to the Foot Controller connector may damage the

device.

• When the Control One is connected, turn the 2112 SGS, GSP-2101, Valve FX or Legend II's power switch

on. Both the signal processor/preamp and the Control One will begin their power-up initialization

sequences. When initialization is complete, the Control One's display will show the number and name of

the currently selected Program on the 2112 SGS, GSP-2101, Valve FX or Legend II.

• To change Programs within the currently selected Bank, press one of the numbered Patch switches on the

pedalboard. The display will change to reflect the name and number of the newly selected Program.

•GSP 2101, Valve FX or Legend II only To recall any Program number, press the Program / Bank Selector

switch once and use the 0-9 pedals to enter the number of the Program you want. If the Program number you

want is lower than 100, you must press the Program / Bank Selector switch again after the number has been

entered. This tells the GSP-2101, Valve FX or Legend II that you are finished entering numbers and to initi-

ate the change.

• GSP 2101, Valve FX or Legend II only To change Banks (a Bank is a group of Programs accessed using

only the 0-9 pedals), press the Program / Bank Selector switch (the top right switch on the pedalboard)twice.

The display of the Control One reads: BANK NUMBER X. X indicates the currently selected Bank number.

• To select a Program in the new Bank press a footswitch (0-9).

• The CC pedal is set from the factory to control at least one Parameter in almost every Program in the 2112

SGS, GSP-2101, Valve FX or Legend II. Try it in each new Program to find out what it does.

Control One Owner's Manual

Section 2 - Basic Operation