DigiTech RP1000 Manual de início rápido - Página 2

Procurar online ou descarregar pdf Manual de início rápido para Interruptor DigiTech RP1000. DigiTech RP1000 2 páginas. Multi-effects switching system
Também para DigiTech RP1000: Manual de configuração (12 páginas)

Imprimir página

USING PRESET & PEDALBOARD MODES

A. To toggle between Preset and Pedalboard modes, press the

button.

PEDALBOARD

B. When the

PEDALBOARD

button is lit, the RP1000 is in Pedalboard mode and pressing the

footswitches will turn individual effects (e.g., compressor, distortion, etc.) on or off, just

6-10

like when using stompboxes on a pedalboard.

C. When the

Toggle between Preset

PEDALBOARD

and Pedalboard modes

button is not lit,

the RP1000 is

in Preset mode

and the

6-10

footswitches will

select presets.

Select presets (Preset mode) or

effects on/off (Pedalboard mode)

SELECTING, EDITING, & STORING PRESETS

A. To select a preset, press the UP or DOWN footswitch to select a different bank then press

one of the 1-5 footswitches (Pedalboard mode) or 1-10 footswitches (Preset mode).

B. Turn the TONE LIBRARY and EFFECTS LIBRARY knobs to select other tones/effect chains.

C. Press the UP/DOWN EDIT buttons to select a specific effect for editing (the selected effect

LED will light). Press the TONE LIBRARY

knob to turn the effect on/off. Look

Press to

Selected

edit effect

effect

select a Bank

at the parameter matrix and use

the KNOBS to edit the effect.

D. To exit Edit mode, press one of the

1-5 footswitches.

E. To store the preset, press the

STORE button.

F. Use the TONE LIBRARY and

EFFECTS LIBRARY knobs to edit

the preset name.

G. Press the STORE button a 2nd time.

H. Optional: Press the UP or DOWN

footswitch to relocate the preset.

Press the STORE button a 3rd time

to store the preset.

Press to select a Preset

DigiTech

• 801.566.8800 • digitech.com

USING THE LOOPER

A. To enable the Looper, press the LOOPER button. The LOOPER LED will light.

NOTE:

When the Looper is enabled, the

DOWN

footwitches will be used for Looper

control, so they cannot be used for preset bank up/down selection.

B. Press the DOWN footswitch to arm the looper for recording. The RECORD LED will begin

flashing.

Press to

C. Begin playing. When done, press the DOWN footswitch again on the same downbeat you

started on.

D. If you want to play over the top of the loop with different guitar tones/effects, select a

different preset or edit the effects.

E. While the loop is playing, press the DOWN footswitch to record an overdub. The OVERDUB

LED will light. When done, press the DOWN

footswitch again to stop overdub recording.

Repeat to record additional overdubs.

F. Press the UP footswitch to stop the Looper and

DOWN footswitch to play the Looper.

G. To clear the loop, stop playback then press and

hold the UP footswitch for 2 seconds. The display

will briefly read "LOOPCLRD". Repeat steps B- E to

record a new loop.

H. To exit the Looper, press the LOOPER button.

DigiTech is a registered trademark of Harman.

QUICK START GUIDE

Enable/Disable Looper

Control Looper

PN: 5059525-A