Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor Manual de instalação do hardware - Página 18
Procurar online ou descarregar pdf Manual de instalação do hardware para Hardware de rede Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor. Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor 36 páginas. User guide
Imprimir páginaInstalling and Removing Line Cards or Motherboards
Use the release levers to push the line card or motherboard or processor card in until it is fully seated in
Step 3
the backplane connector.
Push the release levers in simultaneously to lock the line card or motherboard into the slot.
Step 4
Use a number 1 Philips screwdriver to tighten the captive installation screws.
Step 5
Check the LED to ensure proper installation while powered.
Step 6
Removing Line Cards or Motherboards
To remove a line card or motherboard, follow these steps:
Step 1
Remove all cables from the line card or motherboard.
Step 2
Install appropriate dust covers on the fiber cable connectors and the blind plugs into the connectors on
the motherboard.
Step 3
Use a number 1 Philips screwdriver to loosen the captive installation screws.
Step 4
Pull the release levers out to release the line card or motherboard from the slot in the chassis.
Step 5
Use the release levers to pull the line card or motherboard out of the chassis.
Place the removed line cards in a container appropriate for shipping and storage.
Step 6
Installing SFPs into Aggregation Cards and Muxponders
To install SFPs into the ESCON aggregation cards, 8-port FC/GE aggregation cards, and 8-port
multi-service muxponders, follow these steps:
Take the desired SFP from the shipping container.
Step 1
Install the SFP by inserting it in the aggregation card or muxponder.
Step 2
Push the SFP until you hear a click. The click indicates that it is securely set in the module.
Step 3
Installing SFP with Mini SMB Coax Connectors
To install the 15500-XVRA-10E1SFP with mini SMB coax connectors into the 8-port multi-service
muxponder, follow these steps:
Take the desired SFP from the shipping container.
Step 1
Install the mini SMB coax connector into the SFP by pushing the cable into the SFP. (See
Step 2
Note
Cisco ONS 15530 Hardware Installation Guide
2-18
If you are installing the 15500-XVRA-10E1, you must attach the cable to the SFP before
installing the SFP into the 8-port multi-service muxponder.
Chapter 2
Installing the Cisco ONS 15530
Figure
OL-7706-01
2-14.)